View source for Measuring 15N T1 and T2 relaxation times (Bruker)

== '''Introduction'''  ==

The rotational correlation time of a protein in solution is the time for a protein to rotate one radian. In the limit of slow molecular motion (τ<sub>c</sub> &gt;&gt; 0.5 ns), the correlation time of a protein is related to the ratio of the longitudinal (T<sub>1</sub>) and transverse (T<sub>2</sub>) <sup>15</sup>N relaxation times, and nuclear frequency (ν<sub>N</sub>) according to Eq. 1, which is derived from Eq. 8 in Kay et al. (Ref. 1) by considering only J(0) and J(ω) spectral densities and neglecting higher frequency terms.&nbsp;&nbsp;&nbsp;&nbsp;&nbsp; &nbsp;&nbsp;&nbsp; [[Image:Tc eq1.png|center|250x50px]] 

In practice, global <sup>15</sup>N T<sub>1</sub> and T<sub>2</sub> relaxation times for an unknown protein target can be obtained quickly (ca. 1 h) on a 1.7-mm microcyroprobe using 1D <sup>15</sup>N-edited relaxation experiments (Ref. 2), by fitting integrated signal in the backbone amide <sup>1</sup>H region of the spectrum as a function of delay time to an exponential decay. One then computes the correlation time using Eq. 1, and compares it to a standard curve of τ<sub>c</sub> vs. protein molecular weight (MW) obtained at the same temperature on a series of known monomeric proteins of varying size.&nbsp; As a general rule of thumb, the τ<sub>c</sub> of a monomeric protein in solution in nanoseconds is approximately 0.6 times its molecular weight in kiloDaltons. This approach is reliable up to MW ≈ 25 kDa, where accurate measurement of the diminishing <sup>15</sup>N T<sub>2</sub> becomes problematic. 

<br> 

== '''Methods'''  ==

=== Acquisition of 1D <sup>15</sup>N T<sub>1</sub> and T<sub>2</sub> on Bruker Spectrometers  ===

On Bruker spectrometers equipped with TopSpin 2.1 we use the [[Media:Hsqct1etf3gpsi3d.txt|hsqct1etf3gpsi3d]] and [[Media:Hsqct2etf3gpsi3d.txt|hsqct2etf3gpsi3d]] pulse sequences for the acquisition of <sup>15</sup>N T<sub>1</sub> and T<sub>2</sub> spectra (Ref. 1-3). The 1D version of these experiments are acquired as pseudo 2D spectra, where the <sup>1</sup>H<sup>N</sup> dimension is arrayed vs. delay time. We acquire <sup>1</sup>H-detected 1D <sup>15</sup>N relaxation spectra by using the following settings in the acquisition mode: 

*set the number of acquisition points in the <sup>15</sup>N dimension, td2 = 1 
*set the number of points in the 3rd dimension equal to the number of delay times used in the experiment 
*set the acquisition mode in the 3rd dimension to QF 
*set NBL equal to the number of delay times used in the experiment; this is very important for the experiment to work properly 
*define a vdlist (T<sub>1</sub>) or vclist (T<sub>2</sub>) 
*set d1 to 3 - 5 s (T<sub>1</sub>) or 1.5 - 3 s (T<sub>2</sub>) for adequate relaxation during the experiment.

Typical [[Media:RelaxT1_122807.txt|vdlist]] and [[Media:Relaxt2_122807.txt|vclist]] files are attached. 



At Rutger's University, we obtain the spectra in about 1hr on a Bruker 1.7-mm microcyroprobe.

=== Processing 1D <sup>15</sup>N T<sub>1</sub> and T<sub>2</sub> on Bruker Spectrometers  ===

*To process the pseudo 2D <sup>15</sup>N relaxation date, type:
<pre>xf2
</pre> 
&nbsp;&nbsp; You will be prompted for a new processed data number under you experiment name.<br> 

*Next, extract the first row (into ~TEMP file) and basline correct 
*Return to the processed pseudo2D apply the baseline correction using the command
<pre>bas
</pre> 
*Relaxation data is analyzed using the t1guide package (below) within TopSpin.<br><br>

=== Analyzing 1D <sup>15</sup>N T<sub>1</sub> and T<sub>2</sub> Data Using t1guide  ===

For detailed information on the t1guide routine, consult the help documentation within Topspin 2.1 under Help -&gt; Manuals -&gt; General User Manual. 

*In Topsin 2.1, launch t1guide by typing:
<pre>t1guide
</pre> 
*Extract the first slice of the spectrum using the Extract Slice option and expand on the amide region. 
*Proceed to Peaks/Ranges and perform a manual integration (Figure 2).&nbsp; We typically integrate between δ ≈ 10 to 8.5 ppm.&nbsp; Save the integration region to disk (the diskette/A symbol in the tool bar).<br>

==== Figure 1:&nbsp; Manual Integration of Amide Region in First Slice  ====

[[Image:T1guide integration.png|800px]] 

*Proceed to the Relaxation Window.&nbsp; A plot of integral area vs. delay time will be displayed (Figure 2).&nbsp; Any points that are outliers can be deleted at this point using the mouse.

==== Figure 2: Relaxation Window  ====

[[Image:T1guide relaxation.png|800px]] 

*Proceed to the Fitting Function (Figure 3).&nbsp; Here the user inputs various parameters including the number of points and type of function used to fit the data. We typically use the uxnmrt1 function and we prefer to use the integral area.&nbsp; Be sure to select the correct vdlist or vclist used in the experiment.

==== Figure 3:&nbsp; The Fitting Function  ====

[[Image:T1guide function.png]] 

<br> 

*Proceed to Start Calculation and fit the data (Figure 4)

==== Figure 4: &nbsp;Fitting the Data<br>  ====

[[Image:T1guide T1fit.png|800px]] 

*Finally, the user can also display/print the report and print the plot.

<br> 

=== Compare the New τ<sub>c</sub> to a Standard Plot  ===

The final step in the process is to compare your τ<sub>c</sub> to a standard plot of τ<sub>c</sub> (ns) vs. MW (kDa) for known monomers (Figure 5).&nbsp; Temperature is an extremely important variable here, and it is recommended that all data be acquired at the same temperature, preferably on the same instrument.&nbsp; At Rutgers we have a standard curve obtained at 298 K on our Bruker 600.&nbsp; If your target is significantly above the curve, then it is not a monomer. 

==== Figure 5:&nbsp; Plot of τ<sub>c</sub> vs. MW for Various NESG&nbsp;Monomers  ====

[[Image:T1wiki fig5.png|800px]]<br> 

== <br>'''References'''  ==

1.&nbsp;&nbsp;&nbsp; Kay, L.E., Torchia, D.A. and Bax, A. (1989) Backbone dynamics of proteins as studied by <sup>15</sup>N inverse detected heteronuclear NMR spectroscopy:&nbsp; Application to staphylococcal nuclease. ''Biochemistry 28'', 8972-8979.<br>2.&nbsp;&nbsp;&nbsp; Farrow, N.A., Muhandiram, R., Singer, A.U., Pascal, S.M., Kay, C.M., Gish, G., Shoelson, S.E., Pawson, T., Forman-Kay, J.D. and Kay, L.E. (1994) Backbone dynamics of a free and phosphopeptide-complexed Src homology 2 domain studied by <sup>15</sup>N NMR relaxation. ''Biochemistry 33'', 5984-6003. <br>3.&nbsp;&nbsp;&nbsp; Barbato, G., Ikura, M., Kay, L.E., Pastor, R.W. and Bax, A. (1992) Backbone dyanamics of calmodulin studied by <sup>15</sup>N relaxation using inverse detected two-dimensional NMR spectroscopy. ''Biochemistry 31'', 5269-5278.<br><br> 

-- JimAramini - 10 Nov 2009