AutoStructure

Getting Started

Input Files

The following files are required to perform an AutoStructure run.

Protein sequence file

The sequence file must be in the following format:

1   @   MET    2   @   GLU    3   @   PHE    4   @   PRO    5   @   ASP
6   @   LEU    7   @   THR    8   @   VAL    9   @   GLU    10   @   ILE
....etc.

Here is an example sequence file.

Chemical shift assignment file

The chemical shift assignments for the protein must be in BMRB 2.1 format.  The header information is ignored.

AutoSructure does interpret the ambiguity code column.  This is important for denoting stereospecific assignments.

1       1       Met     HA      H       3.999   .       1
2       1       Met     HB2     H       2.011   .       2
3       1       Met     HB3     H       1.946   .       2
4       1       Met     HG2     H       2.368   .       2
5       1       Met     HG3     H       2.274   .       2
6       1       Met     CA      C       55.110  .       1
7       1       Met     CB      C       33.147  .       1
8       1       Met     CG      C       30.951  .       1
9       2       Glu     HA      H       4.548   .       1
....etc.

Here is an example bmrb file.

NOESY peak lists

AutoStructure can accept 3D and 4D NOESY peak lists.  The column definitions and tolerances are defined in the control file (below). 

Staring a Calculation

The user can start a calculation from either the graphical user face or the command line. 

1. Launching a calculation from the GUI.

• Under the Autostructure pull-down on the main page, choosing Start -> Calc opens the dialogue box below. 

• Launching calculations from the GUI uses is generally slow since only the processors on your own machine are used.  To speed up the calculations use the command line on a cluster.

2.  Launching a calculation from the command line.

• Login in the a cluster.  At CABM we use AutoStructure version 2.2.1 on hummer.
• A simple command line run can be started as follows:

/farm/software/AutoStructure/AutoStructure-2.2.1/bin/autostructure -c controlfile_CYANArun -o testCYANArun.out -v

• Running the autostructure command gives the following options (like those avaliable in the GUI):

 AutoStructure/RPF Version 2.2.1 Copyright(C) 2007
     Center for Advanced Biotechnology and Medicine (CABM)
     Rutgers University

     Options:
         -c control_file      Required
         -o output_dir        Required
         -d                   For debug
         -h                   Help
         -m                   Exclude PCT-filter of Cycle1 for symmetry analysis
         -n                   Exclude CSI-based secondary structure analysis
         -i structure_file    inital fold for bootstrapping
         -j                   Include J-coupling constant data for angle constraint analysis (HYPER)
         -k float_number      Calibration coefficient
         -N                   Include NOE assignments in HYPER caluclation (under development)
         -q structure_file    AutoQF-Calculate the F and DP scores of the input structure_file (IUPAC naming)
         -r path              Restore from a prior outout_dir
         -R                   Include rotamer constraints in HYPER calculation (under development)
         -v                   Calculate the M score and average shifts

References

-- JimAramini - 07 Nov 2009